Subaru Crosstrek Service Manual: Removal

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Set the tire to the straight-ahead position.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

3. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL">

4. Remove the steering wheel. Steering Wheel > REMOVAL">

5. Remove the cruise control command switch assembly. Steering Wheel > DISASSEMBLY">

Inspection

Cruise control system

Other materials:

Installation
MECHANICAL(H4DO) > Chain CoverINSTALLATION1. Install the O-rings to cylinder head RH, cylinder head LH, cylinder block LH and oil pan upper.NOTE:• Use new O-rings.• Apply a coat of engine oil to the O-rings.2. Apply liquid gasket if there are gaps between front camshaft cap and cam ca ...

Dtc p0966 pressure control solenoid "b" control circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0966 PRESSURE CONTROL SOLENOID "B" CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Excessive shift shockCAUTION:Use the check board w ...

Electrical specification
SECURITY AND LOCKS > Keyless Entry SystemELECTRICAL SPECIFICATION1. KEYLESS ENTRY CONTROL MODULE• Model without tire pressure monitoring systemTerminal No.ItemMeasuring conditionStandard3 (U-ART com.) — Cannot be measured — 4 (+B) ←> Chassis groundVoltageAlways10 — 14 V7 (GND) ...