1. Close all windows.
2. Remove the key from the ignition switch (models without "keyless access with push-button start system")/turn the push-button ignition switch to the "OFF" position (models with "keyless access with push-button start system").
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate) but leave only the driver's door or the front passenger's door open.

6. Press the front side ("LOCK" side) of the power door locking switch to set the door locks.
7. Close the door. An electronic chirp will sound once, the hazard warning flashers will flash once and the security indicator light will start flashing rapidly. After rapid flashing for 30 seconds (standby time), the indicator lights will then flash slowly (twice approximately every 2 seconds), indicating that the system has been armed for surveillance.
To arm the system using access
key/remote transmitter
To arm the system using the keyless access function (if equipped)Preparation tool
DIFFERENTIALS > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS398477701HANDLE• Used for installing the rear bearing race.• Used for installing the front bearing race.398477702DRIFT• Used for installing the front bearing race. (T-type) ...
Snow tires
WARNING
When installing winter tires on the Subaru Ascent, it is absolutely essential
that all four tires are identical in the following characteristics.
Size
Speed rating
Load index
Circumference
Construction type
Manufacturer
Brand and tread pattern
Level of wear
...
Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides
the driver with a warning message
by sending a signal from a sensor that is
installed in each wheel when tire pressure
is severely low. The tire pressure monitoring
system will activate only when the
vehicle is driven. Also, this system may
not rea ...