Subaru Crosstrek Owners Manual: Tachometer

Subaru Crosstrek Owners Manual / Instruments and controls / Meters and gauges / Tachometer

The tachometer shows the engine speed in thousands of revolutions per minute.

CAUTION

Do not operate the engine with the pointer of the tachometer in the red zone. In this range, fuel injection will be cut by the engine control module to protect the engine from overrevving.

The engine will resume running normally after the engine speed is reduced below the red zone.

NOTE

To protect the engine/transmission while the select lever is in the "P" or "N" position (for CVT models) or the shift lever is in the neutral position (for MT models), the engine is controlled so that the engine speed may not become too high even if the accelerator pedal is pressed hard.

Double trip meter

Type A Trip knob Type B Trip knob (U.S.-spec. models) Trip knob (except U.S.-spec. models) This meter displays the two trip meters when the ignition switch is in the "ON" positio ...

Fuel gauge

Fuel gauge (type A) Trip knob Fuel gauge (type B) Trip knob (U.S.-spec. models) Trip knob (except U.S.-spec. models) The fuel gauge is displayed when the ignition is in the "O ...

Other materials:

Dtc b2220 break the wire of ign
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2220 BREAK THE WIRE OF IGNDTC detecting condition:There was voltage malfunction caused by poor contact of IGN power supply circuits.Trouble symptom:Airbag indicator does not illuminate.Wiring d ...

Dtc b1000 airbag ecu malfunction
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1000 AIRBAG ECU MALFUNCTIONDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Airbag control module is faulty.CAUTION:Before performing diagnosis, refer to “CAUTION” in “General ...

Rear window wiper blade rubber
1. Pull out the end of the blade rubber assembly to unlock it from the plastic support. 2. Pull the blade rubber assembly out of the plastic support. 1) Metal spines 3. If the new blade rubber is not provided with two metal spines, remove the metal spines from the old blade rubbe ...