Subaru Crosstrek Owners Manual: Registering a Bluetooth Audio device for the first time
To use the Bluetooth Audio, it is necessary to register an audio device with the system.
The device registration procedure is the same for both the hands-free system and Bluetooth audio.
1. Display the "BT Devices Connection" screen. Refer to "Registering a Bluetooth phone for the first time" F5-65.
2. Select the "Add" key.
The "Add" key is not displayed when five devices are already registered.
To add another device, you need to delete one of the registered devices.
Press the 
key for the device to be
deleted, and then select the "OK" key.
3. Register the Bluetooth device using your Bluetooth device.
- A PIN-code is not required for SSP (Secure Simple Pairing) compatible Bluetooth devices. Depending on the type of Bluetooth device being connected, a message confirming registration may be displayed on the Bluetooth device's screen. Respond and operate the Bluetooth device according to the confirmation message.
4. Check that the screen is displayed when registration is complete.
- The system waits for connection requests coming from the registered device.
- At this stage, the Bluetooth functions are not yet available.
Registering a Bluetooth phone for
the first time
To use the hands-free system, it is
necessary to register a Bluetooth phone
with the system.
For details about registering a Bluetooth
device: Refer to "Registering a Bluetooth
Audio device for ...
Profiles
This system supports the following services.
NOTE
If your cell phone does not support HFP, registering the Bluetooth
phone or using OPP, PBAP, or SPP profiles individually
will not be poss ...
Other materials:
Preparation tool
COOLING(H4DO) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS18355AA000PULLEY WRENCH• Used for removing and installing water pump pulley.• Used with PULLEY WRENCH PIN SET (18334AA030).18334AA030PULLEY WRENCH PIN SET• Used for removin ...
Installation
FRONT SUSPENSION > Front StabilizerINSTALLATION1. Before installation, inspect the following items and replace any faulty part with a new one.• Check the bushing - stabilizer for abnormal cracks, fatigue or damage.• Check the stabilizer link for damage.2. Install each part in the reve ...
Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).CAUTION:Be careful not to damage the boot.(2) Remove the ...
