Subaru Crosstrek Owners Manual: Safety precautions
WARNING
Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury.
For models with HID low beam headlights, observe the following precautions. Not doing so carries the risk of an electric shock that could result in serious injury because the HID bulbs use an extremely high voltage.
- Do not replace any headlight bulbs (both low beam and high beam) by yourself.
- Do not remove/restore the headlight assemblies by yourself.
- Do not remove any headlightassembly components by yourself.
For replacement, contact your SUBARU dealer.
CAUTION
Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire.
Bulb chart
...
Bulb chart
NOTE
Lights A and B are the LED (Light Emitting Diode) type. Consult your
SUBARU dealer for replacement.
Wattage
Bulb No.
1) High beam headlight
12V-60W
HB3
...
Other materials:
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR PipeREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move the ...
Engine noise Inspection
MECHANICAL(H4DO) > Engine NoiseINSPECTIONType of soundConditionPossible causeRegular clicking soundSound increases as engine speed increases.• Valve mechanism is defective• Incorrect cam clearance• Worn camshaft• Broken valve spring• Defective valve shimHeavy and dul ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator SensorINSPECTION1. MANUAL A/C MODELWIRING DIAGRAM:1. Prepare the vehicle.NOTE:Check that the ambient temperature is 25 — 40°C (77 — 104°F) and that the humidity is 30% — 80%.• Place the vehicle in the workshop ...
