Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Disassembly

INSTRUMENTATION/DRIVER INFO > Combination Meter

DISASSEMBLY

CAUTION:

Use gloves to avoid damage and getting fingerprints on the glass surface and meter surfaces.

Be careful not to apply excessive force to the trip knob.

Be sure not to touch the meter indicator needle.

Because LEDs are used for all of warning lights and indicator lights, they are not removable from the meter - main assembly.

1. Release the claws, and then remove the glass - combination meter.

2. Release the claws, and then remove the visor - combination meter.

Removal
INSTRUMENTATION/DRIVER INFO > Combination MeterREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the lock, tilt the steering column to the lowest end and fully extend th ...

Installation
INSTRUMENTATION/DRIVER INFO > Combination MeterINSTALLATIONCAUTION:• Make sure the electrical connector is connected securely.• Make sure that each meter operates normally.• When ...

Other materials:

Dtc p0962 pressure control solenoid "a" control circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0962 PRESSURE CONTROL SOLENOID "A" CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Engine speed increases abruptly, and can n ...

Removal
SECURITY AND LOCKS > Remote OpenersREMOVAL1. FRONT HOOD OPENER1. Remove the opener handle.(1) Remove the cable.(2) Remove the bolt, and remove the opener handle.2. After removing the following parts, attach a string to the end of the cable - front hood and remove the cable clip and the cable.&bul ...

Clear memory mode Operation
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, se ...

© 2016-2025 Copyright www.sucross.com