Subaru Crosstrek Service Manual: Installation
INSTRUMENTATION/DRIVER INFO > Combination Meter
INSTALLATION
CAUTION:
• Make sure the electrical connector is connected securely.
• Make sure that each meter operates normally.
• When the combination meter assembly has been replaced, be sure to perform the following operations.
– For models without the keyless access with push button start except for C5, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type B” described in “REGISTRATION MANUAL FOR IMMOBILIZER”.
– Be sure to reset the ODO fuel economy value of the multi-function display (MFD). (High grade type) Multi-function Display (MFD) System > OPERATION">
Install each part in the reverse order of removal.
Disassembly
INSTRUMENTATION/DRIVER INFO > Combination MeterDISASSEMBLYCAUTION:• Use gloves to avoid damage and getting fingerprints on the glass surface and meter surfaces.• Be careful not to apply ...
Other materials:
Dtc b1837 short in curtain airbag lh squib circuit (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1837 SHORT IN CURTAIN AIRBAG LH SQUIB CIRCUIT (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (LH) circuit is shorted to ground.• Curtain airbag ...
Operating tips for heater and air conditioner
Cleaning ventilation grille
Front ventilation inlet grille
To maintain optimal performance of the Subaru Ascent climate system, always keep
the ventilation inlet grille free from snow, debris, leaves, or dirt. Blockages
can reduce heating efficiency and impair defrosting capability.
...
Power supply circuit Wiring diagram
WIRING SYSTEM > Power Supply CircuitWIRING DIAGRAM1. WITHOUT PUSH BUTTON START• Engine room side• Passenger room sideNo.LoadMB-1VDC CMMB-2VDC CMMB-3Wiper relayMB-4Sub fan relayMB-5Mirror heater LHMirror heater RHRear defoggerA/C control panelMB-6Body integrated unitMB-7Main fan relay ...
