Subaru Crosstrek Service Manual: Dtc c1412 selected parameter

DTC DETECTING CONDITION:

VDCCM parameter selection error

TROUBLE SYMPTOM:

• ABS does not operate.

• EBD does not operate.

• VDC does not operate.

• Hill start assist does not operate.

When the VDCCM or VDCCM&H/U is replaced, this DTC may be stored.

1.CHECK VDCCM&H/U IDENTIFICATION SYMBOL.

Check the identification symbol attached on the H/U. General Description > SPECIFICATION">

Is the identification symbol correct?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1412 SELECTED PARAMETER">Go to Step 2.

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

2.CHECK PARAMETER SELECTED IN VDCCM.

Subaru Select Monitor > OPERATION">

Does the parameter registered in the VDCCM match the relevant vehicle?

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

Select and register the correct parameter. Subaru Select Monitor > OPERATION">

Dtc c1411 electrical control module

Dtc c1413 power supply voltage

Other materials:

Average fuel consumption
U.S.-spec. models Except U.S.-spec. models This display shows the average rate of fuel consumption since the trip meter was last reset. Trip knob Pressing the trip knob toggles the display between the average fuel consumption corresponding to the A trip meter display and ...

Inspection
SECURITY AND LOCKS > Keyless Entry SystemINSPECTION1. SYMPTOM CHARTSymptomsRepair orderReferenceNone of the functions of the keyless entry system operate.1. Check the keyless transmitter battery. Keyless Entry System > INSPECTION">2. Remove and visually inspect the following fuses.&bul ...

Dtc b1832 short in curtain airbag rh squib circuit (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1832 SHORT IN CURTAIN AIRBAG RH SQUIB CIRCUIT (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (RH) circuit is shorted to ground.• Curtain airbag ...