Subaru Crosstrek Service Manual: Combination meter system

Installation

INSTRUMENTATION/DRIVER INFO > Combination MeterINSTALLATIONCAUTION:• Make sure the electrical connector is connected securely.• Make sure that each meter operates normally.• When ...

Electrical specification

INSTRUMENTATION/DRIVER INFO > Combination Meter SystemELECTRICAL SPECIFICATION1. COMBINATION METER ASSEMBLYRefer to “Control Module I/O Signal” of “INSTRUMENTATION/DRIVER INFO (DI ...

Other materials:

Dtc p0458 evap system (cpc) purge control valve "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0458 EVAP SYSTEM (CPC) PURGE CONTROL VALVE "A" CIRCUIT LOWDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicing ...

Read diagnostic trouble code (dtc) Operation
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. COMBINATION METER1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each Sy ...

Hill start assist warning light does not go off
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternHILL START ASSIST WARNING LIGHT DOES NOT GO OFFDetecting condition:• Defective combination meter• Defective CAN communicationTrouble symptom:Hill start assist warning light does not go off when starting t ...