Subaru Crosstrek Service Manual: Dtc p062f internal control module eeprom error
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P062F INTERNAL CONTROL MODULE EEPROM ERROR
NOTE:
For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCESSOR">
1. OUTLINE OF DIAGNOSIS
Judge as NG when the EEPROM operation is abnormal. (EEPROM malfunction)
2. COMPONENT DESCRIPTION
(1) | Throttle position sensor | (6) | Accelerator pedal position sensor 2 | (10) | CPU |
(2) | Throttle position sensor 1 | (7) | I/F circuit | (11) | Monitoring IC |
(3) | Throttle position sensor 2 | (8) | Amplifier circuit | (12) | EEPROM |
(4) | Accelerator pedal position sensor | (9) | Engine control module (ECM) | (13) | Output IC |
(5) | Accelerator pedal position sensor 1 |
3. EXECUTION CONDITION
Secondary Parameters | Execution condition |
None |
4. GENERAL DRIVING CYCLE
Always perform the diagnosis continuously.
5. DIAGNOSTIC METHOD
Judge as OK and clear the NG when the malfunction criteria below are met.
Malfunction Criteria | Threshold Value |
Writing-check (EEPROM) | Error |
Time Needed for Diagnosis: 2 times
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc p0617 starter relay "a" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0617 STARTER RELAY "A" CIRCUIT HIGHDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE ...
Dtc p0685 ecm/pcm power relay control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0685 ECM/PCM POWER RELAY CONTROL CIRCUIT/OPENDTC DETECTING CONDITION:Detected when two consecutive driving c ...
Other materials:
Installation
EXTERIOR BODY PANELS > Front HoodINSTALLATIONCAUTION:The hood COMPL - front is heavy. When removing or installing the hinge COMPL - front hood, be sure to work in a group of two or more.1. To install the insulator - front hood and the seal - front duct, follow the removal procedure in the reverse ...
Inspection
GLASS/WINDOWS/MIRRORS > Rear Regulator and Motor AssemblyINSPECTION1. Disconnect the connector of the motor - rear.2. Check the motor operation when battery voltage is applied between terminals of the motor - rear connector.• LH sideTerminal No.Inspection conditionsStandard4 (+) — 1 (&min ...
Interior light system Wiring diagram
WIRING SYSTEM > Interior Light SystemWIRING DIAGRAM1. WITHOUT EyeSight2. WITH EyeSight ...
