Subaru Crosstrek Owners Manual: Reset to factory default settings
1. Perform the preparation steps according to "Preparation for initialization"
2. Operate the " 
" or "
" switch to
select the "Reset to Defaults" item. Then
push the
button.
3. The system will prompt a Yes/No
dialogue ("No" is selected first). To return
to the factory default settings, select "Yes"
by operating the " " switch.
4. Confirm the setting by pushing the
button.
Initialize
Items that have been set to your preference
can be initialized. To select an
initialization menu, operate the "
" or " "
switch as follows.
Preparation for initialization
1. Turn the ignition ...
Lifetime fuel consumption resetting
1. Perform the preparation steps according
to "Preparation for initialization"
2. Operate the " " or "
" switch to
select the "Lifetime Fuel Consumption
Resetting" item. Then push the
butto ...
Other materials:
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door ActuatorREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable f ...
Basic inspection
WIRING SYSTEM > Basic Diagnostic ProcedureBASIC INSPECTION1. VOLTAGE MEASUREMENT1. Using a voltmeter, connect the negative lead to a good ground point or negative battery terminal and the positive lead to the connector or component terminal.2. Contact the positive lead of the voltmeter on connect ...
Installation
DRIVE SHAFT SYSTEM > Propeller ShaftINSTALLATION1. Before installation, check the following items, and replace the propeller shaft assembly as necessary.• Dents or cracks on the tube surface• Splines for deformation or abnormal wear• Unsmooth joint operation or abnormal noise&bu ...
