Subaru Crosstrek Owners Manual: Initialize
Items that have been set to your preference
can be initialized. To select an
initialization menu, operate the " 
" or " 
"
switch as follows.
Preparation for initialization
1. Turn the ignition switch to the "ON" position.
2. Push and hold the
button to show
the selection screen.
3. After the selection screen is displayed,
operate the " 
" or "
" switch to show the
"Initialize" item. Then, push the 
button.
Keyless access setting (models with "keyless access with pushbutton start
system")
Preparation for keyless access settings
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Keyless Access Set ...
Reset to factory default settings
1. Perform the preparation steps according
to "Preparation for initialization"
2. Operate the " " or "
" switch to
select the "Reset to Defaults" item. Then
push the button.
...
Other materials:
Disassembly
STARTING/CHARGING SYSTEMS(H4DO) > GeneratorDISASSEMBLY1. Remove the cap from the generator.2. Remove four bolts.3. Use a drier to heat the rear cover (A) portion to 50 — 60°C (122 — 140°F).4. Insert a flat tip screwdriver or similar tool wrapped with protective tape into ...
Installation
CLUTCH SYSTEM > Operating CylinderINSTALLATION1. Install in the reverse order of removal.NOTE:• Before installing the operating cylinder, apply grease to the contact point of the release lever and operating cylinder.Grease:NICHIMOLY N-130 or equivalent• Be sure to install the clutch h ...
Dtc p2009 tgv control circuit low bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2009 TGV CONTROL CIRCUIT LOW BANK 1DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION"& ...
