1. Perform the preparation steps according to "Preparation for initialization"

2. Operate the "
" or "
" switch to
select the "Lifetime Fuel Consumption
Resetting" item. Then push the
button.

3. The system will prompt a Yes/No
dialogue ("No" is selected first). To reset
the lifetime fuel consumption, select "Yes"
by operating the "
" switch.

4. Confirm the setting by pushing the
button.

5. Reconfirmation will be displayed. If
you are sure you want to proceed, select
"Yes" by operating the "
" switch.

6. Confirm the setting again by pushing
the
button.

7. The system will notify you that the setting is complete.
Reset to factory default settings
Light control switchFuel system trouble in general Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel System Trouble in GeneralINSPECTIONTroublePossible causeCorrective actionInsufficient fuel supply to fuel injectora. Fuel pump does not operate. Defective terminal contactInspect contact, especially ground, and tighten it securely. Trouble in elec ...
Reverse function
WARNING
Keep all body parts clear when operating the Subaru Ascent reverse function.
If the system fails to react properly, serious injury may occur.
The Subaru Ascent reverse function may not activate if an object is trapped
just before the rear gate fully closes. Always exercise cautio ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearINSTALLATION1. Install the reverse shifter lever, adjusting washer, reverse idler gear, reverse idler gear shaft and washer, and secure them with the straight pin.NOTE:• Be sure to install the reverse idler gear shaft from rear s ...