Subaru Crosstrek Service Manual: Dtc u0402 invalid data received from tcm
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0402 INVALID DATA RECEIVED FROM TCM
NOTE:
For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">
1. OUTLINE OF DIAGNOSIS
Detect malfunction of CAN communication.
Judge as NG when data received from TCM, VDC CM and combination meter is not normal.
2. COMPONENT DESCRIPTION
(Common Specifications)
CAN Protocol 2.0 B (Active)
Frame Format: 11 Bit ID Frame (Standard Frame)
Conforms to ISO11898
Communication Speed: 500 kbps
3. EXECUTION CONDITION
Secondary Parameters | Execution condition |
Battery voltage | ≥ 10.9 V |
4. GENERAL DRIVING CYCLE
Perform the diagnosis continuously after starting the engine.
5. DIAGNOSTIC METHOD
Judge as NG when the following conditions are established.
Malfunction Criteria | Threshold Value |
CAN data from TCM | Did not change |
CAN data from TCM | Parity error |
Time Needed for Diagnosis: 2 seconds
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc u0155 lost communication with instrument panel cluster (ipc) control module
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULENOTE:For the diagnostic procedure, ...
Dtc u0416 invalid data received from vehicle dynamics control module
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULENOTE:For the diagnostic procedure, refer to L ...
Other materials:
At oil temp warning light (CVT models)
If this light illuminates when the engine is
running, it may indicate that the transmission
fluid temperature is too hot.
If the light illuminates while driving, immediately
stop the vehicle in a safe place
and let the engine idle until the warning
light turns off.
Transmission control ...
Service mode (models without "keyless access with push-button start system")
In service mode, the remote engine start
function is temporarily disabled to prevent
the system from unexpectedly starting the
engine while being serviced.
To engage or disengage service mode:
1. Enter the vehicle and close all vehicle
doors and the rear gate.
2. Verify that the select le ...
Removal
WIPER AND WASHER SYSTEMS > Front Wiper Motor and LinkREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">3. Remove the cowl panel assembly. Cowl Panel > REMOVAL">CAUTION:Before removin ...
