Subaru Crosstrek Service Manual: Assembly
BRAKE > Master Cylinder
ASSEMBLY
CAUTION:
When replacing the reservoir tank, adhere the label to the position shown in the figure. (C5 model)
Preparation items:
C5 model
Part No.: Label (25080GA010)
(a) | Label | (b) | Brake booster |
1. Install the seal to the cylinder body assembly.
2. Install the reservoir tank.
CAUTION:
Be careful not to tighten a vise excessively.
(1) Place the master cylinder assembly between aluminum plates and fix it on a vise.
(2) Drive the pin using a punch and a hammer to install the reservoir tank.
Master cylinder
...
Removal
BRAKE > Master CylinderREMOVALCAUTION:• Do not allow brake fluid to come in contact with the painted surface of the vehicle body. If it does, wash off with water and wipe away completely.&bul ...
Other materials:
BSD/RCTA OFF indicator
System temporary stops
BSD/RCTA temporary stop message
BSD/RCTA OFF indicator
In the Subaru Ascent, this message is displayed when the BSD/RCTA system is temporarily
suspended due to external or internal conditions that prevent accurate operation.
Extremely high or extremely low a ...
Folding down the seatback
WARNING
Never allow passengers to sit on folded seatbacks or remain in the cargo
area of the Subaru Ascent, as this can lead to serious injury or death.
Secure long items such as skis or equipment properly to prevent them
from moving freely and causing injury during sudden stops or maneu ...
Removal
ENTERTAINMENT > Rear Accessory Power Supply SocketREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the console box assembly. Console Box > REMOVAL">3. Remove the socket assembly.(1) While releasing the c ...
