Subaru Crosstrek Service Manual: Read diagnostic trouble code (dtc) Operation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Keyless Access with Push Button Start» and then select «Enter».
5. On «Select Function» display, select «DTC».
NOTE:
• For detailed operation procedures, refer to “Application help”.
• For details concerning DTC, refer to “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)">
List of diagnostic trouble code (dtc) List
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LIST(1) Keyless access systemDTCItemContent of diagnosisNoteU0073CONTROL MODULE COMMUNICATION BUS O ...
System operation check mode Operation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > System Operation Check ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target ...
Other materials:
Radar sensor
Adjustment
Blind Spot Detection/Rear Cross Traffic Alert > Radar SensorADJUSTMENT1. RADAR AXIS ADJUSTMENTCAUTION:• After removal/installation or replacement of the radar sensor, perform the radar axis adjustment.• The procedure for the master is only shown here. However the procedure ...
Caution
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > General DescriptionCAUTION• Remove contamination including dirt and corrosion before removal, installation or disassembly.• Keep the disassembled parts in order and protect them from dust and dirt.• Do not place the valve cover with it ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainINSPECTION• Check the oil pump chain for damage.• Replace if gear teeth are broken, damaged, sharpen or excessively worn.• Check the bearing for seizure or wear.• Apply CVTF to bearing and rotate the bearing to chec ...
