COOLING(H4DO) > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |

18355AA000
PULLEY WRENCH
• Used for removing and installing water pump pulley.
• Used with PULLEY WRENCH PIN SET (18334AA030).

18334AA030
PULLEY WRENCH PIN SET
• Used for removing and installing water pump pulley.
• Used together with PULLEY WRENCH (18355AA000).

—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Circuit tester | Used for measuring resistance, voltage and current. |
Radiator cap tester | Used for checking radiator and radiator cap. |
DST-i | Used together with Subaru Select Monitor 4. |
Component
RadiatorTilting moonroof
Raise
Lower
The tilting function is activated only when
the moonroof is fully closed.
To raise:
Press the rear side of the "UP/DOWN"
switch momentarily. The moonroof raises
completely.
To lower:
Press and hold the front side of the "UP/
DOWN" switch until the preferred positi ...
Inspection
COMMUNICATION SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and check visually.2. If the fuse is blown out, replace the fuse.2. CHECK RELAY1. Check the resistance between relay terminals.Terminal No.Inspection conditionsSpecificationCircuit1 — 2Always1 M? or more1 — 2Apply ...
Automatic headlight beam leveler warning light (models with HID headlights)
This
light illuminates when the automatic
headlight beam leveler does not operate
normally.
If this light illuminates while driving or does
not turn off approximately 3 seconds after
turning the ignition switch to the "ON"
position, have your vehicle inspected at
your SUBARU dealer.
Fr ...