Subaru Crosstrek Service Manual: Removal
EXTERIOR/INTERIOR TRIM > Mud Guard
REMOVAL
1. Lift up the vehicle.
2. Remove the wheels.
3. Remove the screws and clips to remove the mud guard.
(1) | Under cover - front | (2) | Mud guard - front | (3) | Mud guard - rear |
Installation
EXTERIOR/INTERIOR TRIM > Mud GuardINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Wheel nut:Except for C4 model: 120 N·m (12.24 kgf-m, 88.5 ft-lb) C4 model: 1 ...
Rear bumper
...
Other materials:
Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorDISASSEMBLY1. Disconnect the drain tube (A) from the leak check valve assembly.NOTE:Disconnect the quick connector as shown in the figure.2. Lift up the claw (B) of the drain separator and slide the drain separator in the dir ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearASSEMBLY1. Set the ST against the inner race of the ball bearing, and install the transfer drive gear.CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Use a new ball bearing.ST 398177700INSTALLER ...
Dtc p2530 ignition switch run position circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2530 IGNITION SWITCH RUN POSITION CIRCUITDTC detecting condition:Immediately at fault recognitionTrouble symptom:Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Cl ...
