Subaru Crosstrek Service Manual: Installation

Subaru Crosstrek Service Manual / Exterior/interior trim / Mud guard / Installation

EXTERIOR/INTERIOR TRIM > Mud Guard

INSTALLATION

Install each part in the reverse order of removal.

Tightening torque:

Wheel nut:

Except for C4 model: 120 N·m (12.24 kgf-m, 88.5 ft-lb)
C4 model: 100 N·m (10.2 kgf-m, 73.8 ft-lb)

EXTERIOR/INTERIOR TRIM > Mud GuardREMOVAL1. Lift up the vehicle.2. Remove the wheels.3. Remove the screws and clips to remove the mud guard.(1)Under cover - front(2)Mud guard - front(3)Mud guard - ...

Other materials:

Brake system warning light (red)
The light illuminates with the parking brake applied while the ignition switch is in the "ON" position. It turns off when the parking brake is fully released. WARNING Driving with the brake system warning light on is dangerous. This indicates your brake system may not be working ...

Inspection
DRIVE SHAFT SYSTEM > Propeller ShaftINSPECTIONCheck the propeller shaft with the propeller shaft installed to the vehicle.1. Remove the front exhaust pipe. Front Exhaust Pipe > REMOVAL">2. Remove the center exhaust pipe, rear exhaust pipe, and muffler.• Center exhaust pipe & ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve AssemblyREMOVAL1. Release the fuel pressure. Fuel > PROCEDURE">2. Disconnect the ground cable from battery.3. Remove the intake manifold. Intake Manifold > REMOVAL">4. Disconnect the connector (A) from the tumble ...