Subaru Crosstrek Service Manual: Installation
INSTRUMENTATION/DRIVER INFO > Steering Switch
INSTALLATION
CAUTION:
• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
• Do not allow harness and connectors to interfere or get tangled up with other parts.
• If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform the VDC setting mode. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">
• Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.
1. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT">
2. Install each part in the reverse order of removal.
NOTE:
Align the alignment marks on the steering wheel and the column assembly - steering.
Tightening torque:
Steering wheel: 39 N·m (3.98 kgf-m, 28.8 ft-lb)
Clearance:
Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in)
Removal
INSTRUMENTATION/DRIVER INFO > Steering SwitchREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM ...
Eco gauge Specification
INSTRUMENTATION/DRIVER INFO > ECO GaugeSPECIFICATIONSince the meter - main assembly cannot be disassembled, do not remove or inspect the ECO gauge alone. (Do not remove the cover on the back surfac ...
Other materials:
Dtc c2424 transmitter 4 battery voltage low
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2424 TRANSMITTER 4 BATTERY VOLTAGE LOWDTC DETECTING CONDITION:Detected when power supply voltage failure signal is received from each transmitter.TROUBLE SYMPTOM:Tire pressure warning light ...
Inspection
BRAKE > Stop Light SwitchINSPECTION1. CLEARANCE CHECKNOTE:Check for clearance is applied only to LED model.1. Measure the clearance between the end of the stop light switch and the stopper.Specification:Clearance (A) of the stop light switch: 1 mm — 2 mm (0.04 in — 0.08 in)(a)Stop light switc ...
Dtc p2138 throttle/pedal position sensor/switch "d"/"e" voltage correlation
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2138 THROTTLE/PEDAL POSITION SENSOR/SWITCH "D"/"E" VOLTAGE CORRELATIONDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Improper idling• Poor driving pe ...
