Subaru Crosstrek Service Manual: Removal
INSTRUMENTATION/DRIVER INFO > Steering Switch
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Set the tire to the straight-ahead position.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL">
4. Remove the steering wheel. Steering Wheel > REMOVAL">
5. Remove the MID switch. Steering Wheel > DISASSEMBLY">
Inspection
INSTRUMENTATION/DRIVER INFO > Steering SwitchINSPECTION1. Measure the resistance between switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard3 — 2 (UP)i/SET ( ...
Installation
INSTRUMENTATION/DRIVER INFO > Steering SwitchINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “ ...
Other materials:
Drain filter Specification
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain FilterSPECIFICATIONThe leak check valve assembly is a non-disassembled part. Do not remove the drain filter from the leak check valve assembly. Refer to “Leak Check Valve Assembly” for removal and installation procedures. ...
Dtc u0140 lost communication with body control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0140 LOST COMMUNICATION WITH BODY CONTROL MODULEDetected when CAN data from BIU does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PRO ...
Assembly
STARTING/CHARGING SYSTEMS(H4DO) > StarterASSEMBLY1. Apply grease to the shaft sliding surfaces of the internal gear assembly.Grease:Multemp #6129 or equivalent2. Assemble the shaft to the internal gear assembly.3. Assemble the overrunning clutch as follows:(1) Apply grease to the spline portion o ...
