Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Condenser

INSTALLATION

CAUTION:

• If the condenser assembly - air conditioner has been replaced, add an appropriate amount of compressor oil. Compressor Oil > ADJUSTMENT">

• Replace the O-rings with new parts, and then apply compressor oil.

• Confirm that the lower guide of condenser assembly - air conditioner fits into the holes on radiator panel.

1. Install each part in the reverse order of removal.

Tightening torque:

Air conditioning unit: General Description > COMPONENT">

Radiator upper bracket: General Description > COMPONENT">

2. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">

Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CondenserREMOVAL1. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE">2. Remove the air ...

Control panel
...

Other materials:

Removal
WIPER AND WASHER SYSTEMS > Wiper BladeREMOVAL1. FRONTWhile pushing the locking clip (A) up, pull out the blade assembly - windshield wiper in the direction of the arrow, and remove it from the arm assembly - windshield wiper.2. REARTurn the blade assembly - rear wiper in the direction of arrow (A ...

Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > CanisterREMOVAL1. Lift up the vehicle.2. Remove the rear exhaust pipe. Rear Exhaust Pipe > REMOVAL">3. Remove the propeller shaft. Propeller Shaft > REMOVAL">4. Support the rear differential with the transmission jac ...

Self-check screen
When the ignition switch is turned to the "ON" position, the vehicle self-check will be performed. The screens corresponding to the following items will appear one after another for several seconds each. Engine oil: Checks the interval of engine oil replacement. Oil filter: Checks th ...

© 2016-2026 Copyright www.sucross.com