Subaru Crosstrek Service Manual: Control panel

Installation

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CondenserINSTALLATIONCAUTION:• If the condenser assembly - air conditioner has been replaced, add an appropriate amount of compressor oil. Compress ...

Inspection

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Control PanelINSPECTION1. CHECK ILLUMINATION1. Check the illumination operation when battery voltage is applied between the terminals of control panel.&bu ...

Other materials:

Assembly
EXTERIOR/INTERIOR TRIM > Door TrimASSEMBLY1. Bend the claws while pushing the weather strip - door INN against the door trim so that there is no gap.CAUTION:Beware of the direction of folding the claws.(a)Rivet(b)Direction of folding claws(c)Claw bending direction: bend forward for LH side, backw ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodINSTALLATION1. Install the check ball spring and check ball to the reverse fork rod arm, and press in the ST.ST 399411700ACCENT BALL INSTALLER2. Install the reverse fork rod through the hole on the rear of the transmission case. P ...

Operating range for push-button start system
Antenna Operating range NOTE If the access key is not detected within the operating range of the antennas inside the vehicle, the pushbutton ignition switch and the engine start cannot be operated. Even when the access key is outside the vehicle, if it is placed too close to the ...