Subaru Crosstrek Service Manual: Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Coolant Temperature Sensor
INSTALLATION
Install in the reverse order of removal.
NOTE:
Use a new gasket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Coolant Temperature SensorREMOVAL1. Disconnect the ground cable from battery.2. Drain engine coolant. Engine Coolant > REPLACEMENT">3. Disco ...
Other materials:
Removal
EXTERIOR/INTERIOR TRIM > Glove BoxREMOVALNOTE:Refer to “Security and Locks” section for key cylinder replacement. Key Lock Cylinders > REPLACEMENT">1. Remove the pocket assembly.(1) Attach the protective tape (a) to the panel center LWR.(2) Remove the damper COMPL - pocket ...
Brake fluid
Checking the fluid level
WARNING
Prevent brake fluid from coming into contact with your eyes when servicing
your Subaru Ascent, as it can cause serious irritation or injury. If exposure
occurs, rinse immediately with clean water and seek medical attention if necessary.
Wearing protecti ...
Replacement
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Oil SealREPLACEMENT1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Clean the transmission exterior.4. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.CAUTION:• Immediately after ...
