Subaru Crosstrek Service Manual: Inspection
COOLING(H4DO) > Reservoir Tank
INSPECTION
1. Check that the reservoir tank does not have deformation, cracks or damage.
2. Make sure the over flow hoses are not cracked, damaged or loose.
3. Make sure the engine coolant level is between “FULL” and “LOW”.
Reservoir tank
...
Removal
COOLING(H4DO) > Reservoir TankREMOVAL1. Disconnect the over flow hose (A) connected to the radiator filler neck from the reservoir tank.2. Pull out the reservoir tank to the arrow direction while p ...
Other materials:
Bulkhead wiring harness (in compartment) Location
WIRING SYSTEM > Bulkhead Wiring Harness (In Compartment)LOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionB274B-4 Blower Resistor (manual A/C)B308BlackC-5 Front door cord RHB3110GrayC-1AB1Airbag wiring harnessB328B-2 Turn signal and hazard unitB4016BlackC-1 Data link connectorB412C-2 Po ...
Safety precautions
WARNING
Bulbs may become very hot while
illuminated. Before replacing
bulbs, turn off the lights and wait
until the bulbs cool down. Otherwise,
there is a risk of sustaining
a burn injury.
For models with HID low beam
headlights, observe the following
precautions. Not doing so carries
the ...
Dome light and cargo area light
Dome light
Cargo area light
1. Remove the lens by prying the edge of
the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
Other bulbs
It may be difficult to replace the bulbs.
Have the bulbs replaced by your
...
