Subaru Crosstrek Service Manual: Inspection

Subaru Crosstrek Service Manual / Continuously variable transmission(tr580) / Forward clutch assembly / Inspection

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch Assembly

INSPECTION

• Check the forward clutch drum, internal gear, sun gear and forward clutch piston lip for wear or damage.

• Inspect the drive plate facing for wear and damage.

• Check the driven plate for discoloration (burnt color).

• Check for worn snap ring, fatigue or damaged return spring or deformed spring retainer.

• Make sure the clearance between retaining plate and internal gear of forward clutch is within the limit. If it exceeds the standard, replace the forward clutch. Forward Clutch Assembly > ASSEMBLY">

Disassembly

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyDISASSEMBLY1. FORWARD CLUTCH ASSEMBLY1. Remove the snap ring.2. Remove the retaining plate, drive plate, driven plate and dish pla ...

Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyINSTALLATION1. Install the thrust bearing to the converter case.NOTE:Face the temper color surface to the converter case side.2. I ...

Other materials:

Dtc b2276 acc relay off signal
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2276 ACC RELAY OFF SIGNALDTC detecting condition:When input error occurs in accessory relay cut input signal of keyless access CM.Trouble symptom:• The accessory power su ...

Installation
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse order of removal.Tightening torqueGarnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 f ...

Dtc u1500 keyless uart com. Malfunction
BODY CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1500 KEYLESS UART COM. MALFUNCTION1. MODEL WITHOUT KEYLESS ACCESS WITH PUSH BUTTON START SYSTEMDTC detecting condition:UART between the TPMS & keyless control module or keyless entry CM and the bod ...