Subaru Crosstrek Owners Manual: How to change the source
The AUX operation screen can be reached by the following methods:
- Connect a portable audio device. Refer to "Connecting and disconnecting a USB memory/portable device"
- Select the "AUX" key on the source select screen. Refer to "Selecting an audio source"
Audio level settings
You can set the audio gain level.
1. Select the 
tab on the screen,
and
then touch the right side key of the "Audio
Level" key.
2. Select the audio level from the following items.
- Low
- Mid
- High
Control screen and audio panel
Select to display the audio source
selection screen.
level settings"
Turn to adjust volume.
Press to turn the audio system on/off.
Press to select an audio source.
Refer to "S ...
Steering switches for audio
Some parts of the audio/visual system can
be adjusted using the switches on the
steering wheel.
+ − switch
switch
Mute/Enter switch
List switch
Back switch
Source switch
...
Other materials:
Tachometer
The tachometer shows the engine speed
in thousands of revolutions per minute.
CAUTION
Do not operate the engine with the
pointer of the tachometer in the red
zone. In this range, fuel injection will
be cut by the engine control module
to protect the engine from overrevving.
The engine will ...
Dtc p2012 tgv control circuit low bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2012 TGV CONTROL CIRCUIT LOW BANK 2DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION"& ...
Assembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftASSEMBLYCAUTION:Wrap shaft splines with vinyl tape to protect the boot from scratches.NOTE:Use specified grease.Grease:BJ, EBJ side: NKG814DOJ side: NKG8141. Install the inner race to the shaft.(1) Install the boot (BJ) or boot (EBJ) in the specified position, ...
