Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: General description

Installation
STARTING/CHARGING SYSTEMS(H4DO) > Battery Current & Temperature SensorINSTALLATION1. BATTERY CURRENT SENSORInstall in the reverse order of removal.Tightening torque: General Description > CO ...

Caution
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Add ...

Other materials:

Disassembly
CONTROL SYSTEMS > MT Gear Shift LeverDISASSEMBLY1. Remove the lock wires.(A)Lock wire2. Remove the rod from gear shift lever.(A)Rod(B)Lever(C)Stay3. Separate the rod and inner boot.4. Remove the snap ring from the stay.(A)Snap ring5. Separate the gear shift lever and the stay.6. Remove the boot a ...

Inspection
LIGHTING SYSTEM > Hazard SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply battery voltage between the connector terminals to check the lighting ...

Inspection
ENTERTAINMENT > Rearview Camera SystemINSPECTION1. Park the vehicle at the level place where there are enough area at the rear of the vehicle.2. Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.NOTE:Standard tape width is about 30 ...

© 2016-2026 Copyright www.sucross.com