Subaru Crosstrek Service Manual: Dtc p0341 camshaft position sensor "a" circuit range/performance bank 1 or single sensor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P0341 CAMSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCE BANK 1 OR SINGLE SENSOR
NOTE:
For the diagnostic procedure, refer to DTC P0340. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0340 CAMSHAFT POSITION SENSOR "A" CIRCUIT BANK 1 OR SINGLE SENSOR">
1. OUTLINE OF DIAGNOSIS
Detect the malfunction of camshaft position sensor property.
Judge as NG when the number of camshaft signals remains abnormal.
2. COMPONENT DESCRIPTION
(A) | Camshaft signal (RH) | (B) | Camshaft signal (LH) | (C) | Crankshaft signal |
(D) | Camshaft position signal: When normal, there will be 3 camshaft position signals for every 2 crankshaft revolutions. |
3. EXECUTION CONDITION
Secondary Parameters | Execution condition |
Battery voltage | ≥ 8 V |
Elapsed time after starting the engine | ≥ 200 ms |
4. GENERAL DRIVING CYCLE
Always perform the diagnosis continuously.
5. DIAGNOSTIC METHOD
Judge as NG when the status where the number of camshaft position sensor signal in two crankshaft revolutions is other than 3 time(s).
Malfunction Criteria | Threshold Value |
Amount of camshaft sensor signal during 2 revs of crankshaft | ≠ 3 time(s) |
Time Needed for Diagnosis: Two engine revs. ? 4 time(s)
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc p0340 camshaft position sensor "a" circuit bank 1 or single sensor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0340 CAMSHAFT POSITION SENSOR "A" CIRCUIT BANK 1 OR SINGLE SENSORDTC DETECTING CONDITION:Immediate ...
Dtc p0345 camshaft position sensor "a" circuit bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0345 CAMSHAFT POSITION SENSOR "A" CIRCUIT BANK 2DTC DETECTING CONDITION:Immediately at fault recog ...
Other materials:
Removal
SEATS > Rear SeatREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing sensor is located in the lowe ...
Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...
Towing
If towing is necessary, it is best done by
your SUBARU dealer or a commercial
towing service. Observe the following
procedures for safety.
WARNING
Never tow AWD models with the
front wheels raised off the ground
while the rear wheels are on the
ground, or with the rear wheels
raised off t ...
