Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV Valve

REMOVAL

CAUTION:

Do not remove unless the PCV valve is broken.

1. Disconnect the PCV hose from the intake manifold and the PCV valve, and then remove the PCV hose.

2. Remove the clip (A) holding the air breather hose from the engine hanger. (MT model)

3. Disconnect the connector (B) from manifold absolute pressure sensor. (MT model)

4. Disconnect the connector (C) from the throttle position sensor. (MT model)

5. Disconnect the connector (D) from the EGR control valve. (MT model)

6. Remove the PCV valve from the cylinder block RH.

Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV ValveINSPECTION1. PCV VALVE1. Check that the PCV valve has no deformation, cracks or other damages.2. Check that air is discharged from ...

Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV ValveINSTALLATIONInstall in the reverse order of removal.NOTE:Apply liquid gasket to the bolt threads of PCV valve.Liquid gasket:THREE B ...

Other materials:

Gross Axle Weight (GAW) and Gross Axle Weight Rating (GAWR)
Gross Axle Weight The total weight applied to each axle (GAW) must never exceed the Gross Axle Weight Rating (GAWR). The front and rear GAWs can be adjusted by relocating passengers and luggage inside the vehicle. The front and rear GAWR of your vehicle that is given by SUBARU are also ...

Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelINSPECTION1. PADDLE SHIFT SWITCHCheck the resistance of paddle switch.STEPCHECKYESNO1.SHIFT-UP SWITCH CONTINUITY CHECK.1) Operate the + side of paddle shift assembly and hold it.2) Measure the resistance between terminals of the paddle shift ...

Installation
MECHANICAL(H4DO) > V-beltINSTALLATION1. V-BELTInstall in the reverse order of removal.CAUTION:• When reusing the V-belt, wipe off dust and water with cloth.• Do not use the V-belt if there is any oil, grease or coolant on the belt.• Be careful not to rub the V-belt end surface w ...

© 2016-2026 Copyright www.sucross.com