Subaru Crosstrek Service Manual: Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV Valve
INSTALLATION
Install in the reverse order of removal.
NOTE:
Apply liquid gasket to the bolt threads of PCV valve.
Liquid gasket:
THREE BOND 1324 (Part No. 004403042) or equivalent
Tightening torque:
23 N·m (2.3 kgf-m, 17.0 ft-lb)
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV ValveREMOVALCAUTION:Do not remove unless the PCV valve is broken.1. Disconnect the PCV hose from the intake manifold and the PCV valve, ...
Other materials:
Removal
SECURITY AND LOCKS > Impact SensorREMOVAL1. Pull out the key from the ignition switch, or turn off the power.2. Close all the doors and rear gate.3. Press the UNLOCK button of the keyless transmitter or access key.4. Disconnect the ground cable from battery. NOTE">5. Remove the impact se ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Sub Level SensorINSPECTION1. Check that the fuel sub level sensor has no damage.2. Measure the fuel sub level sensor float position.(1)FULL(2)EMPTY(3)Datum pointsFloat positionStandardFULL to Datum point (A)5.31±3.5 mm (0.209±0.138 in)EMPTY to Datum po ...
Installation
LUBRICATION(H4DO) > Engine Oil FilterINSTALLATION1. OIL FILTERCAUTION:Do not tighten excessively, or oil may leak.1. Clean the oil filter installation surface.2. Obtain a new oil filter and apply a thin coat of engine oil to the seal rubber.3. Install the oil filter by turning it by hand, being c ...
