Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc p0202 cylinder 2 injector "a" circuit

ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P0202 CYLINDER 2 INJECTOR "A" CIRCUIT

NOTE:

For the diagnostic procedure, refer to DTC P0201. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0201 CYLINDER 1 INJECTOR "A" CIRCUIT">

1. OUTLINE OF DIAGNOSIS

NOTE:

For the detection standard, refer to DTC P0201. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0201 CYLINDER 1 INJECTOR "A" CIRCUIT">

Dtc p0201 cylinder 1 injector "a" circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0201 CYLINDER 1 INJECTOR "A" CIRCUITDTC DETECTING CONDITION:Immediately at fault recognitionTROUBL ...

Dtc p0203 cylinder 3 injector "a" circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0203 CYLINDER 3 INJECTOR "A" CIRCUITNOTE:For the diagnostic procedure, refer to DTC P0201. Diagno ...

Other materials:

Control unit Note
CRUISE CONTROL SYSTEM > Control UnitNOTESystem control of the cruise control is performed by each module. For procedure, refer to the following sections.• Engine control module (ECM): Engine Control Module (ECM)">• Transmission control module (TCM): Transmission Control Modu ...

Inspection
SECURITY AND LOCKS > ReceiverINSPECTION1. Check if the door lock operates when the touch sensor of the door outer handle and rear lock button is operated.2. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS A ...

Removal
STARTING/CHARGING SYSTEMS(H4DO) > Battery Current & Temperature SensorREMOVAL1. BATTERY CURRENT SENSORNOTE:Remove the battery current sensor and battery cable as a unit.1. Disconnect the battery ground cable and remove the clip from the battery rod.2. Remove the battery terminal boot.3. Remov ...

© 2016-2024 Copyright www.sucross.com