Subaru Ascent 2018-2026 Owner's Manual: If you park your vehicle in case of an emergency
When an unexpected situation occurs and you must stop your Subaru Ascent, always activate the hazard warning flashers to clearly alert other road users, regardless of whether it is day or night.
Whenever possible, avoid stopping directly on the roadway. Instead, carefully maneuver your Subaru Ascent to a safe location off the road to minimize the risk of a collision.
The hazard warning system can be engaged at any time, even if the ignition switch is not in the active position, ensuring that your Subaru Ascent remains visible to surrounding traffic.
To activate the system, press the hazard warning switch once. Press it again to turn the system off after the situation is resolved.
NOTE
While the hazard warning flashers are active, the turn signal function of the Subaru Ascent will be temporarily disabled.
Maintenance tools
Your Subaru Ascent is equipped with a set of essential maintenance tools designed
to assist in emergency situations and basic roadside service tasks.
Extension x 2
Wheel nut wrench
Jack ...
Other materials:
Inspection
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingINSPECTION1. Moving the rear tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is unsmooth sliding operation or abnormal noise in the bearing, replace the rear hub unit bearing.2. Inspe ...
Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the lid assembly - sunroof. Glass Lid > REMOVAL">3. Remove the trim panel - roof assembly. Roof Trim &g ...
Installation
DRIVE SHAFT SYSTEM > Front Hub Unit BearingINSTALLATION1. Place the front brake back plate between the front axle housing and the front hub unit bearing, and tighten the bolt.CAUTION:• Do not get closer the tool which charged magnetism to magnetic encoder.• Be careful not to damage th ...
