Subaru Crosstrek Service Manual: Disassembly
DRIVE SHAFT SYSTEM > Rear Axle
DISASSEMBLY
1. BUSHING - REAR AXLE HOUSING
Do not remove the bushing - rear axle housing from the rear axle housing, because it cannot be replaced. If removed, replace the rear axle housing.
2. REAR BUSHING
1. Remove the rear axle housing. Rear Axle > REMOVAL">
2. Using the ST and a hydraulic press, push out the bushing.
Preparation tool:
ST1: BUSHING REMOVER (20099FG000)
ST2: INSTALLER & REMOVER (BASE) (20099PA010)
(1) | Rear axle housing | (2) | Rear bushing |
Removal
DRIVE SHAFT SYSTEM > Rear AxleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen ...
Installation
DRIVE SHAFT SYSTEM > Rear AxleINSTALLATION1. Temporarily tighten the rear axle housing to the upper arm assembly.2. Install the rear drive shaft assembly.CAUTION:• Do not hammer the drive sha ...
Other materials:
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorINSTALLATIONCAUTION:If lubricant is spilt over the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire.1. Before installing front oxygen (A/F) sensor, apply anti-seize compound only to the threaded portio ...
Installation
LUBRICATION(H4DO) > Oil Pressure SwitchINSTALLATION1. Apply liquid gasket to the oil pressure switch threads.Liquid gasket:THREE BOND 1324 (Part No. 004403042) or equivalent2. Install the oil pressure switch to the chain cover.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)3. Connect the ...
To increase the speed (by the "RES/ SET" switch)
Press the "RES/SET" switch to the "RES"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
U.S.-spec. models
When the difference between the actual
vehicle speed and ...
