Subaru Crosstrek Service Manual: Disassembly
CLUTCH SYSTEM > Operating Cylinder
DISASSEMBLY
1. Remove the boot and push rod.
2. Apply compressed air through clutch hose attachment hole.
NOTE:
Face the piston hole down and place a piece of wood underneath to prevent the piston from popping out.
3. Separate the piston and piston spring.
Removal
CLUTCH SYSTEM > Operating CylinderREMOVALCAUTION:Brake fluid spilled on the vehicle body will harm the paint surface; therefore, wash it off with water and wipe clean quickly if spilled.1. Disconne ...
Inspection
CLUTCH SYSTEM > Operating CylinderINSPECTION1. Check that the operating cylinder is not damaged. Replace the operating cylinder if it is damaged.2. Check the brake fluid leakage on the operating cy ...
Other materials:
User customizing Operation
BODY CONTROL SYSTEM (DIAGNOSTICS) > User CustomizingOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, select ...
Inspection
INSTRUMENTATION/DRIVER INFO > Steering SwitchINSPECTION1. Measure the resistance between switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard3 — 2 (UP)i/SET (DOWN)All OFFApprox. 1 M? or more (UP)ONLess than 1 ?i/SETONApprox. 1,000 ? (DOWN)ONApprox. 3,670 ?2. ...
Removal
EXTERIOR/INTERIOR TRIM > Rear BumperREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...
