Subaru Crosstrek Service Manual: Installation
DIFFERENTIALS > Rear Differential Front Member
INSTALLATION
1. Install the rear differential front member, and temporarily attach and tighten a new self-locking nut.
2. Remove the transmission jack.
3. Tighten the self-locking nut.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 110 N·m (11.2 kgf-m, 81.1 ft-lb)
Removal
DIFFERENTIALS > Rear Differential Front MemberREMOVAL1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Support the rear differential using transmission jack, and then remove the ...
Other materials:
Dtc b2810 incompatible with eyesight (combination meter)
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2810 INCOMPATIBLE WITH EyeSight (COMBINATION METER)Detected when the combination meter, which is not designed exclusively for EyeSight is installed.DTC DETECTING CONDITION:Incorrect specifications of combination ...
Removal
SECURITY AND LOCKS > Keyless Access Outdoor AntennaREMOVAL1. FRONT ANTENNACAUTION:Do not remove the antenna from the front door outer handle.If replacement is needed, replace the front outer handle assembly as a set.Remove the handle - door outer. Front Outer Handle > REMOVAL">2. REAR ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)INSPECTION1. Check the resistance between resistor terminals.Preparation tool:Circuit testerTerminal No.StandardConnection diagram4 — 3Approx. 0.43 ?4 — 2Approx. 1.03 ?4 — 1Approx. 3 ?2. Replace the resistor if the ...
