Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

DIFFERENTIALS > Rear Differential Front Member

REMOVAL

1. Disconnect the ground cable from battery.

2. Lift up the vehicle.

3. Support the rear differential using transmission jack, and then remove the rear differential front member.

(A)

Rear differential front member

Inspection
DIFFERENTIALS > Rear Differential Front MemberINSPECTION1. Check the rear differential front member for damage, bend and corrosion.If damage, bend or corrosion is excessive, replace the rear differ ...

Installation
DIFFERENTIALS > Rear Differential Front MemberINSTALLATION1. Install the rear differential front member, and temporarily attach and tighten a new self-locking nut.2. Remove the transmission jack.3. ...

Other materials:

Dtc p2101 throttle actuator "a" control motor circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2101 THROTTLE ACTUATOR "A" CONTROL MOTOR CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performance&bull ...

Canceling the function for meter/gauge needle movement upon turning on the ignition switch
It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the "ON" position. Type A combination meter To change the setting, perform the following procedure. 1. Turn the ignition switch to the "LOCK"/ ...

Towing with all wheels on the ground
1. Release the parking brake and put the transmission in the "N" position. 2. The ignition switch should be in the "ON" position while the vehicle is being towed. 3. Take up slack in the towline slowly to prevent damage to the vehicle. WARNING Never turn the ignition switch to t ...

© 2016-2025 Copyright www.sucross.com