Subaru Crosstrek Service Manual: Diagnostics with phenomenon Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Diagnostics with Phenomenon
INSPECTION
Refer to “Diagnostics with Phenomenon” for “HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS)” section. Diagnostics with Phenomenon">
A/c filter Replacement
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > A/C FilterREPLACEMENT1. Remove the pocket assembly.(1) Attach the protective tape (a) to the panel center LWR.(2) Remove the damper COMPL - pocket.(3) Rel ...
Pressure switch (triple pressure switch) Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Pressure Switch (Triple Pressure Switch)INSPECTION1. Connect the manifold gauge to the service valve on the high-pressure side.2. Disconnect the connector ...
Other materials:
Dtc b1660 passenger s airbag on indicator failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1660 PASSENGER’S AIRBAG ON INDICATOR FAILUREDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Passenger’s airbag indicator is faulty.• Airbag control module is faulty.&b ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSPECTION1. MAGNET CLUTCH CLEARANCE INSPECTION1. Check the clearance of entire circumference around the drive plate and pulley.Specification:0.3 — 0.6 mm (0.0118 — 0.0236 in)2. Replace the compressor assembly if the inspection result is no ...
System operation
Operating conditions
The BSD/RCTA will operate when all of
the following conditions are met.
The ignition switch is in the "ON"
position.
The BSD/RCTA warning indicator and
BSD/RCTA OFF indicator are turned off.
The vehicle is driven at speeds above
6 mph (10 km/h) (except when rever ...
