Subaru Crosstrek Service Manual: Installation
BRAKE > Master Cylinder
INSTALLATION
1. Replace the seal sub assembly for the master cylinder assembly with a new part.
CAUTION:
Be careful not to install the seal sub assembly in the wrong location.
(a) | Primary piston | (b) | Seal sub ASSY | (c) | Install the seal sub assembly to this surface. |
2. Install each part in the reverse order of removal.
Tightening torque:
Master cylinder assembly: 13 N·m (1.33 kgf-m, 9.6 ft-lb)
Brake pipe flare nut: 19 N·m (1.94 kgf-m, 14.0 ft-lb)
3. Bleed air from the brake system. Air Bleeding > PROCEDURE">
Disassembly
BRAKE > Master CylinderDISASSEMBLY1. Remove the reservoir tank.CAUTION:Be careful not to tighten a vise excessively.(1) Place the master cylinder assembly between aluminum plates and fix it on a vi ...
Rear brake pad
...
Other materials:
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchDISASSEMBLY1. Remove the snap ring, and then remove the pressure plate, drive plate and driven plate.(A)Snap ring2. Compress the return spring using the ST to remove the snap ring.ST 18762AA001COMPRESSOR SPECIAL TOOL(A)Snap ring(B)Tran ...
Certification for the Hands-free system
This device complies with Part 15 of FCC
Rules and Industry Canada's licenceexempt
RSSs. Operation is subject to
the following two conditions: (1) This
device may not cause harmful interference,
and (2) this device must accept any
interference received, including interference
that may cause u ...
Installation
WIPER AND WASHER SYSTEMS > Rear WasherINSTALLATION1. Install each part in the reverse order of removal.Tightening torque:Light assembly - high-mounted: 4.5 N·m (0.46 kgf-m, 3.3 ft-lb)Roof spoiler assembly: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)2. Check the nozzle - rear washer position. R ...
