Subaru Crosstrek Service Manual: A/c filter Replacement
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > A/C Filter
REPLACEMENT
1. Remove the pocket assembly.
(1) Attach the protective tape (a) to the panel center LWR.
(2) Remove the damper COMPL - pocket.
(3) Release the stoppers and remove the pocket assembly by pulling it toward you.
2. Pinch the tabs to release the lock, and remove the filter kit.
NOTE:
Pull out while tilting the front side of the filter downward to prevent dirt or dust from falling inside the case.
3. Install each part in the reverse order of removal.
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Sunload Sensor (Auto A/C Model)INSTALLATIONInstall each part in the reverse order of removal. ...
Diagnostics with phenomenon Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Diagnostics with PhenomenonINSPECTIONRefer to “Diagnostics with Phenomenon” for “HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS)” section. D ...
Other materials:
Read diagnostic trouble code (dtc) Operation
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select Sy ...
Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorDISASSEMBLY1. Disconnect the drain tube (A) from the leak check valve assembly.NOTE:Disconnect the quick connector as shown in the figure.2. Lift up the claw (B) of the drain separator and slide the drain separator in the dir ...
Removal
LIGHTING SYSTEM > Rear Turn Signal Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear com ...
