Subaru Crosstrek Owners Manual: Canceling the function for meter/gauge needle movement upon turning on the ignition switch
It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the "ON" position.
Type A combination meter
To change the setting, perform the following procedure.
1. Turn the ignition switch to the "LOCK"/ "OFF" or "ACC" position.
1) Trip knob
2. Press the trip knob to show " ON" or "OFF" on the trip meter display.
The display can be switched as shown in
the following sequence by pressing the
trip knob. 
*: They cannot be displayed when the ignition switch is in the "ON" position.
To change the current setting, press the trip knob for at least 2 seconds.
ON - Activated
OFF - Deactivated
NOTE
- Your vehicle's initial movement setting of the meter/gauge needles has been set for activation " ON" at the time of shipment from the factory.
- It is not possible to change the initial movement setting of the meter/gauge needles when the ignition switch is in the "ON" position. Change the setting when the ignition switch is in the "LOCK"/"OFF" or "ACC" position.
Type B combination meter
Perform the procedures described in "Gauge Initial Movement" 3-41.
Speedometer
The speedometer shows the vehicle speed.
Combination meter illumination
When the ignition switch is turned to the
"ON" position, various parts of the combination
meter will illuminate in the following
sequence.
1. Warning lights, indicator lights, meter
needles, gaug ...
Odometer
Type A
Trip knob
Type B
Trip knob (U.S.-spec. models)
Trip knob (except U.S.-spec. models)
This meter displays the odometer when
the ignition switch is in the "ON" position.
Th ...
Other materials:
Assembly
CLUTCH SYSTEM > Master CylinderASSEMBLY1. Apply a coat of grease to the contact surfaces of the push rod and piston before installation.Grease:SILICONE GREASE G-40M or equivalent2. Assemble in the reverse order of disassembly.Tightening torque:10 N·m (1.0 kgf-m, 7.4 ft-lb) ...
Note
WIPER AND WASHER SYSTEMS > Wiper and Washer SystemNOTEFor procedure of each component of the wiper and washer system, refer to the respective sections.• Combination switch (wiper): Combination Switch (Wiper)">• Wiper blade: Wiper Blade">• Front wiper arm: Fron ...
Preparation tool
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subar ...
