Subaru Crosstrek Service Manual: Basic diagnostic procedure Procedure
AIRBAG SYSTEM (DIAGNOSTICS) > Basic Diagnostic Procedure
PROCEDURE
| STEP | CHECK | YES | NO |
1.CHECK WARNING LIGHT.
Check whether the airbag warning light in the combination meter is lit.
Does the airbag warning light illuminate?
Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.
Perform the diagnosis according to phenomenon of the problem.
2.READ DTC.
1) Turn the ignition switch to OFF.
2) Connect the Subaru Select Monitor to data link connector.
3) Turn the ignition switch to ON and run the Subaru Select Monitor.
4) Read the DTC. (Current malfunction) Read Diagnostic Trouble Code (DTC)">
NOTE:
If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Subaru Select Monitor > INSPECTION">
5) Record all DTCs, time stamp and freeze frame data.
NOTE:
For time stamp, refer to “LAN SYSTEM”. General Description > CAUTION">
Are any DTCs displayed?
Basic Diagnostic Procedure > PROCEDURE">Go to Step 3.
Go to “Airbag Warning Light Failure” Airbag Warning Light Failure">.
3.PERFORM DIAGNOSIS.
1) Determine the possible cause from “List of Diagnostic Trouble Code (DTC)” List of Diagnostic Trouble Code (DTC)">.
2) Inspect the DTC using “List of Diagnostic Trouble Code (DTC)”.
3) Repair the trouble cause.
4) Perform the Clear Memory Mode. Clear Memory Mode">
5) Perform the Inspection Mode. Inspection Mode">
6) Read any other DTCs displayed. Read Diagnostic Trouble Code (DTC)">
Are any DTCs displayed?
Perform the procedure 1) to 5) in step 3.
Finish the diagnosis.
Airbag warning light illumination pattern Inspection
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag Warning Light Illumination PatternINSPECTIONTurn the ignition switch to ON, and confirm that the airbag warning light remains on for approx. 6 seconds then turn ...
Batch save of event record data Operation
AIRBAG SYSTEM (DIAGNOSTICS) > Batch save of Event record dataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and sel ...
Other materials:
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Wiring HarnessINSTALLATION1. Route the engine wiring harness around the engine and connect connectors.• Structural diagram 1(1)Tumble generator valve actuator RH(2)Be careful of pinching when installing the intake manifold.(3)Engine harness conne ...
Daylight saving time setting
1. Perform the preparation steps according
to "Preparation for date setting" 3-
56.
2. Operate the "
" or "
"
switch to
select the "Daylight Saving Time" item.
Then push the
button.
3. The current setting will be displayed.
Push the
button to enter the selection ...
Inspection
LIGHTING SYSTEM > Headlight SystemINSPECTION1. AUTO HEADLIGHT SYSTEM CHECKSTEPCHECKYESNO1.CHECK HEADLIGHT ILLUMINATION.Set the lighting switch to the switch 1 (TAIL/PARKING) and switch 2 (HEAD).Do the tail and headlight illuminate? Headlight System > INSPECTION">Go to Step 2.Check the ...
