Subaru Crosstrek Service Manual: Airbag warning light illumination pattern Inspection
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag Warning Light Illumination Pattern
INSPECTION
Turn the ignition switch to ON, and confirm that the airbag warning light remains on for approx. 6 seconds then turns off afterwards.
(1) | Airbag warning light |
(2) | Approx. 6 seconds |
(3) | Ignition switch ON |
Airbag connector Procedure
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag ConnectorPROCEDUREFor operation procedures, refer to “Airbag Connector” of Airbag System. Airbag Connector"> ...
Basic diagnostic procedure Procedure
AIRBAG SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.CHECK WARNING LIGHT.Check whether the airbag warning light in the combination meter is lit.Does the airbag warning l ...
Other materials:
Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Pressure SensorINSPECTION1. Start and warm up the engine.2. Depress the brake pedal, and shift the select lever to “D” range.3. Shift the select lever to “P” or “N” range.4. Depress the brake pedal and hold ...
Installation
GLASS/WINDOWS/MIRRORS > Rear Quarter GlassINSTALLATION1. Fabricate the cartridge nozzle tip as shown and set the sealant gun with the adhesive.(1)10 mm (0.39 in)(2)8 mm (0.31 in)(3)Sealant gun2. Smoothen and clean the adhesive surfaces of the glass - rear quarter and body using the same procedure ...
