Subaru Crosstrek Service Manual: Assembly

Subaru Crosstrek Service Manual / Continuously variable transmission(tr580) / Transfer driven gear / Assembly

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Driven Gear

ASSEMBLY

1. Using the ST, install the ball bearing.

ST 899580100

INSTALLER

Removal

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Driven GearREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the ext ...

Disassembly

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Driven GearDISASSEMBLY1. Remove the ball bearing using ST.ST1 498077400BEARING REMOVERST2 899864100REMOVER ...

Other materials:

Replacement
COOLING(H4DO) > Engine CoolantREPLACEMENT1. DRAINING OF ENGINE COOLANT1. Turn the ignition switch to OFF.2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL">4. Remove the drain plug to drain engine coolant into container.NOTE:Remove the radiator cap so that ...

Preparation tool
MECHANICAL(H4DO) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS0920287002000REMOVER AND REPLACERUsed for removing and installing valve spring.498277200STOPPER SETUsed for preventing the torque converter from falling when removing and installing the e ...

Inspection
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingINSPECTION1. Moving the rear tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is unsmooth sliding operation or abnormal noise in the bearing, replace the rear hub unit bearing.2. Inspe ...