Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Disassembly

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Driven Gear

DISASSEMBLY

1. Remove the ball bearing using ST.

ST1 498077400BEARING REMOVER
ST2 899864100REMOVER

Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Driven GearASSEMBLY1. Using the ST, install the ball bearing.ST 899580100INSTALLER ...

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Driven GearINSPECTION• Check the ball bearing for smooth rotation.• Check the ball bearing for excessive looseness.• Check the ...

Other materials:

Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Control Valve BodyINSTALLATION1. Clean the mating surface of valve cover and transmission side.CAUTION:When cleaning the mating surface of the transmission side, be careful not to allow any dust, foreign matter and used liquid gasket to enter the transm ...

Dtc p0852 park/neutral switch input circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0852 PARK/NEUTRAL SWITCH INPUT CIRCUIT HIGH1. AT MODELDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicing or replacing ...

© 2016-2025 Copyright www.sucross.com