ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P0700 TRANSMISSION CONTROL SYSTEM (MIL REQUEST)
NOTE:
For the diagnostic procedure, refer to CVT section. Basic Diagnostic Procedure">
1. OUTLINE OF DIAGNOSIS
Judge as NG when there is CAN communication with the TCM and there is a MIL lighting request.
2. EXECUTION CONDITION
Secondary Parameters | Execution condition |
MIL lighting request from TCM | Yes |
3. GENERAL DRIVING CYCLE
Always perform the diagnosis continuously.
4. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
Battery voltage | ≥ 10.9 V |
Time Needed for Diagnosis: 128 ms
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc p0685 ecm/pcm power relay control circuit/open
Dtc p081a starter disable circuit lowService mode (models without "keyless access with push-button start system")
In service mode, the remote engine start
function is temporarily disabled to prevent
the system from unexpectedly starting the
engine while being serviced.
To engage or disengage service mode:
1. Enter the vehicle and close all vehicle
doors and the rear gate.
2. Verify that the select le ...
Removal
LIGHTING SYSTEM > Front Turn Signal Light BulbREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Turn the steering wheel in the opposite direction from the parts to be removed. Then remove the clips and turn over the mud guard - front.3. Remove the bulb socket and front turn si ...
Wiring diagram
LUBRICATION(H4DO) > Oil Level SwitchWIRING DIAGRAM• Engine electrical system Engine Electrical System > WIRING DIAGRAM">• CAN communication system CAN Communication System > WIRING DIAGRAM"> ...