Subaru Crosstrek Service Manual: Wiring diagram
LUBRICATION(H4DO) > Oil Level Switch
WIRING DIAGRAM
• Engine electrical system Engine Electrical System > WIRING DIAGRAM">
• CAN communication system CAN Communication System > WIRING DIAGRAM">
Inspection
LUBRICATION(H4DO) > Oil Level SwitchINSPECTION1. INSPECTION WHEN LOW ENGINE OIL WARNING LIGHT IS ILLUMINATEDSTEPCHECKYESNO1.CHECK ENGINE OIL LEVEL.Is engine oil level normal? Oil Level Switch > ...
Installation
LUBRICATION(H4DO) > Oil Level SwitchINSTALLATION1. Install the oil level switch and the clip (A) to the oil pan upper.NOTE:• Use new O-rings.• Apply a coat of engine oil to the O-rings. ...
Other materials:
Dtc u0100 lost communication with ecm/pcm a
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”Detected when CAN data from the engine control module (ECM) does not arrive.NOTE:Perform the diagnosis for LAN system. Basi ...
Removal
CONTROL SYSTEMS > MT Gear Shift LeverREMOVAL1. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.2. Remove the console box. Console Box > REMOVAL">3. Remove the gear shift knob and remove the ...
Preparation
1. Turn off the ignition switch.
2. Close all doors (including rear gate).
3. Press and hold the " "
button on the
access key. All doors (including rear gate)
will then be locked.
4. Keep the " " button
pressed, and
press the rear lock button within 5
seconds after step ...
