Subaru Crosstrek Service Manual: Wiring diagram
EyeSight (DIAGNOSTICS) > Control Module I/O Signal
WIRING DIAGRAM
Refer to “EyeSight System” in the wiring diagram. EyeSight System">
System block diagram
EyeSight (DIAGNOSTICS) > Control Module I/O SignalSYSTEM BLOCK DIAGRAMMain signals used between stereo camera and relevant CM*: With high grade MFD only ...
Other materials:
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Type A combination meter
To change the setting, perform the following
procedure.
1. Turn the ignition switch to the "LOCK"/ ...
Inspection
WIPER AND WASHER SYSTEMS > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.2. CHECK RELAY1. Check the resistance between relay terminals.Terminal No.Inspection conditionsStandardCircuit1 — 2Always1 M? or more1 — 2Apply ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > EvaporatorREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from batt ...
