Subaru Crosstrek Service Manual: System block diagram
EyeSight (DIAGNOSTICS) > Control Module I/O Signal
SYSTEM BLOCK DIAGRAM
Main signals used between stereo camera and relevant CM
*: With high grade MFD only
Electrical specification
EyeSight (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION1. STEREO CAMERATerminal No.ContentMeasuring conditionStandard(R137) No. 1 — — — (R137) No. 2 — — — (R137) ...
Wiring diagram
EyeSight (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAMRefer to “EyeSight System” in the wiring diagram. EyeSight System"> ...
Other materials:
Dtc p2746 intermediate shaft speed sensor "b" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2746 INTERMEDIATE SHAFT SPEED SENSOR "B" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• ...
Low fuel warning light
The
low fuel warning light illuminates
when the tank is nearly empty, at approximately
2.6 US gal (10.0 liters, 2.2 Imp gal).
It only operates when the ignition switch is
in the "ON" position.
CAUTION
Promptly put fuel in the tank whenever
the low fuel warning light
illuminates. Engine ...
Starting engine
CAUTION
Do not operate the starter motor
continuously for more than 10 seconds.
If the engine fails to start after
operating the starter for 5 to 10
seconds, wait for 10 seconds or
more before trying again.
NOTE
It may be difficult to start the engine
when the battery has been disconnecte ...
