Subaru Crosstrek Owners Manual: Starting engine
CAUTION
Do not operate the starter motor continuously for more than 10 seconds.
If the engine fails to start after operating the starter for 5 to 10 seconds, wait for 10 seconds or more before trying again.
NOTE
It may be difficult to start the engine when the battery has been disconnected and reconnected (for maintenance or other purposes). This difficulty is caused by the electronically controlled throttle's self-diagnosis function. To overcome it, keep the ignition switch in the "ON" position for approximately 10 seconds before starting the engine.
General precautions when starting/stopping engine
WARNING
Never start the engine from outside
the vehicle (except when
using the remote engine start
system). It may result in an
accident.
Do not leave the engine running
in locations w ...
MT models
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Depress the clutch pedal to the floor
and shift the shift lever into neutral. Hold
the clutch pedal to the floor ...
Other materials:
Dtc b1610 front sub sensor rh failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1610 FRONT SUB SENSOR RH FAILUREDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front sub sensor (RH) is faulty.If DTC B1610 is displayed, the circuit within the front sub sensor (RH) is faulty ...
Dtc b1628 side airbag sensor lh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1628 SIDE AIRBAG SENSOR LH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Side airbag sensor (LH) an ...
Inspection
LIGHTING SYSTEM > Interior Light SystemINSPECTION1. CHECK DOOR SWITCHRefer to the “INSPECTION” of the “Door Switch”. Door Switch > INSPECTION">2. CHECK REAR GATE LATCH SWITCHRefer to “INSPECTION” of the “Rear Gate Latch and Actuator Assembly&r ...
